I was assisting a customer this week in upgrading to vSphere and installing and running vReplicator from Vizioncore. vReplicator is not a complex product but works well for what it does: replicate VMs. During the install of vReplicator, we setup replication for a few VMs. The product has a few options for how to determine what to replicate. Since we were now on ESX4 on source and target, I suggested we use Changed Block Tracking mode (CBT) for replication.
When I suggested CBT to the customer they asked, “Why that one?” and how it worked. So I explained: When we replicate from source to target, the first copy is a full copy of the data (the “seed” it is often called). When we go to replicate the next time, we don’t want to replicate the whole thing again, just what has changed since the last time we replicated (often called a “differential”). The replication software needs to determine what’s changed. Prior to ESX 4, there was not a built in method to do this. The software would have to find another method, such as compare snapshot information and determine which blocks are new. That uses CPU cycles on the ESX hosts and takes time (differential mode in vReplicator takes roughly 1 minute per GB of VM data). On the other hand, CBT is a feature in ESX4 that tracks the block changes that have occurred since a point in time. It does not keep a copy of the changed data in a separate location, just a log that the blocks in question have changed. This is a huge help to backup and replication technologies who typically have to determine what has changed on the disks via their own methods. Now, ESX can tell them directly what has changed and they can get right to copying those changed blocks. This makes the overall replication and backup jobs much quicker.
Now for a few lessons learned in using it. First, it requires hardware version 7 VM’s (HW7) and ESX4. VM’s need to have their VMtools upgraded to the latest version and then you can upgrade the VMs to HW7 when they are powered off via right clicking them (this updates the virtual hardware presented to the VMs and will require another reboot in Windows after powering it on when the OS discovers the new virtual HW and loads the drivers – thanks Microsoft!). Second, CBT it is not on by default. It is set per VM and is an advanced option you can set in the VM’s config. Some software have the capability to change the CBT setting for you. In our case, vReplicator has this option on the CBT options page. On that page, it will check every VM that it can see and if they are HW7. If they are HW7, they will show as supported. On that screen, you will also see a checkbox for the “enabled” field. When you click the enabled box on your HW7 VMs, vReplicator makes the change for you in the VM’s configuration. However, as mentioned earlier, you must completely power down that VM and power it back on. The reason for this is that, to start using it, ESX needs to create the tracking log for each disk (the log is about .5MB for ever GB of VMDK or Virtual Mapped RDM and it’s stored with the VM) and ESX only does this setup process at VM boot time. So make note, a restart won’t work. It has to be a VM power down and VM power back on. There is a great article that taught me a few things on CBT by Eric Siebert that goes into a little more technical detail and you can find it here.
Once we got this process completed, my customer’s replication jobs ran MUCH faster. The data being copied from the source to the target was the same, but the time it took vReplicator to determine what to replicate went from minutes to seconds. Great news too was that we were able to change the replication method on the fly (from Differential to CBT, if you’re using hybrid, I think you need to re-seed).
My final advice, is make sure you understand if your backup/replication software can use CBT and what you need to enable it. It does take a bit of work to upgrade the tools and virtual hardware (use Update Manager!). However it’s well worth it in the long run.
Recent Comments